Filter
Top Products
ELAR 216 Panel
™
©Elation Professional, Los Angeles Ca. 22 www.ElationLighting.com
without a controller.
“Auto Program”” – Auto Program Mode
This function allows the internal programs to run in either stand-alone or
master/salve mode. In “Master” mode the fixture will send command data to all other
fixtures connect via the DMX chain. In “Alone” mode the fixture will operate as a
single fixture. The program for this mode is selected in the “Select program”
section of the control menu. You can set the number of steps under “Edit program”.
You can edit the individual scenes under “Edit scenes”. With this function, you can
run the individual scenes either automatically, i.e. with the adjusted Step-Time.
9.2 Information:
Time information
These functions will detail different time functions associated with the fixture.
Current Time
This function displays the running time of the fixture from the last power on. The
display shows “XXXX”, where “XXXX” represents the number of hours the fixture
has been running. This counter is automatically reset after every power-on.
Total Life Hours
This function tracks the total running time of the fixture from the very first start-up.
Where “XXXX ”represents the total number of running hours. This time is none
destructive and will remain in the fixtures memory indefinitely.
Last Run Hours
This function is user resettable and can be used to track hours for a specific amount
of time. The setting can be reset at any time.
Timer Password
This command will reset the “Last Run Hours” described above. Enter the password
to reset the timer to zero. The Access code to reset the timer data is “038.”