Filter
Top Products
EdgeStar Portable Air Conditioner 4
Window Kit Installation Instructions
You must vent your portable air conditioner when running in it
cooling mode and heating mode (HS model). Your unit includes a
window exhaust kit that can be used to vent the unit out a window.
Before you begin, make sure you have all the parts necessary for
installation.
Window Kit Parts List:
If you have multiple windows, choose one that is near an electrical outlet
that will be able to provide sufficient power to your unit. See the power
requirements listed on the product label printed on the side, or on the
back of your portable air conditioner.
Your window kit can be installed on a horizontal or vertical sliding window
as shown in the following pictures:
Follow the instructions on the next pages to install the window kit.
Preparations for installing
the window kit
4 Duct Connectors
2 Grated Adapters
8 Screws
2 Exhaust Hoses
2 Exhaust Covers
1 Window Kit Plate
with Holes
2 Window Kit Plates
NOTE: You may need to
contact your electrician if
your room’s circuit is not
able to power your unit.
Note: This unit can be used with one or two vent hoses. The exhaust hose should always be used in cooling
and heating (HS model) mode. The air intake hose can be used to increase the cooling efficiency of the unit.
If the air intake hose is not used, simply cover one of the grated adapters on the window kit with a vent cap.
NOTE: Exhaust Covers
may be attached to the
Grated Adapters. You
may need to twist and
pull apart to separate
them.