Filter
Top Products
Wa t e r Pu m P
OP e r a t O r 's ma n u a l
19
NOTE
The throttle cable remains assembled to the engine cover and the
spark plug lead and grommet remain installed.
IMPORTANT
DO NOT use a metal scraper to remove dirt from the cylinder ns.
3. Use the brush to remove dirt from the cylinder ns.
4. Remove grass and leaves from the grid between the starter and fuel
tank.
5. When installing the cover, be certain the tab of the metal deector
shield is in the slot of the cover.
e X h a u s t s y s t e m
Spark Arrestor Screen
Level2.
Tools Required: Cross-head Screwdriver, 3 mm Hex Wrench, Soft
metal brush
Parts Required: Spark Arrestor Screen, Gasket
1. Remove engine cover. See “Cleaning Cooling System” for step by
step instructions.
2. Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
3. Remove screen cover (A), screen holder (B), gasket (C), and spark
arrestor screen (D) from mufer body.
4. Clean carbon deposits from screen (D) and mufer components.
5. Replace screen if it is cracked, plugged or has holes burned
through.
6. Install spark arrestor screen, gaskets, and cover.
A
B
C
D