Echo ES-2100 Vacuum Cleaner User Manual


 
23
S
HRED
'N' V
AC
®
O
PERATOR
'
S
M
ANUAL
SHREDDER BLADE
Level 1.
WARNING DANGER
Never remove vacuum tube or open fan guard when SHRED 'N'
VAC
®
is running or serious personal injury may result.
1. With engine stopped, remove spark plug wire, loosen clamp and
pull vacuum tube from unit.
2. Remove accumulated debris from blade and inspect for damage.
IMPORTANT
Do not operate SHRED 'N' VAC
®
if shredder blade is damaged or
broken. Keep retaining nut on blade securely tightened.
3. Refer to "Installing Vacuum Tube" (page 12) in assembly section
for correct assembly procedures.
EXHAUST SYSTEM
Spark Arrestor Screen
Level 2.
Tools required: 13 x 19 mm (1/2 x 3/4 in.) T-Wrench, Cross Head
Screwdriver, Soft metal brush
Parts Required: Screen P/N 14586240630, Gasket Lid P/N 14586642031
1. Remove engine cover (A). See “Cleaning Cooling System” page
22 for step by step instructions.
2. Place piston at Top Dead Center (TDC) to prevent carbon/dirt
from entering cylinder.
3. Remove spark arrestor screen cover (B), screen holder (C),
gasket (D) and screen (E) from muffler body.
4. Clean carbon deposits from screen and muffler components.
5. Replace screen if it is cracked, plugged or has holes burned
through.
6. Assemble components in reverse order.
NOTE
When installing the engine cover, be certain the tab of the metal
deflector shield is in the slot of the cover.
B
C
D
E