Filter
Top Products
16
2. Close Choke - Cold Start.
Move choke (B) to "Cold Start" Position.
3. Primer Bulb -Prime.
Pump primer bulb (C) 10 times. Fuel will be visible and flow freely
in the clear fuel tank return line.
IMPORTANT
Recoil starter: Use short pulls - only 1/2-2/3 of rope for starting.
Do not allow the rope to snap back in. Always hold the unit firmly.
4. Lay the blower on a flat clear area. Firmly grasp throttle grip with
left hand and rapidly pull starter handle/rope (D) until engine fires.
5. After engine fires, move choke lever to “Run” position and pull
starter handle/rope (D) until engine starts and runs. Allow unit to
warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 4 pulls,
repeat instructions.
6. After engine warm up, gradually depress throttle trigger to
increase engine RPM to operating speed.
STARTING WARM ENGINE
1. Stop Switch - Start/Run. Move stop switch button (A) away from
the STOP position.
2. Lay the blower on a flat clear area. Firmly grasp throttle grip with
left hand and rapidly pull recoil starter handle/rope (D) until
engine fires.
IMPORTANT
Recoil starter: Use short pulls - only 1/2-2/3 of rope for starting.
Do not allow the rope to snap back in. Always hold the unit firmly.
NOTE
If engine does not start after 4 pulls, use Cold Start Procedure.
B
C
D