Filter
Top Products
A.) FUEL TANK
FLUSH EVERY 200 HOURS OF
OPERATION OR AS NEEDED (SEE
STORAGE, PAGE 9)
B.) UPPER SHELL REMOVAL
-Remove Screw that secure Side Cover.
-Push out for arrow direction and extract Side
Cover's Bracket from Rectancle Hole and
Separate Side Cover(R).
-Side Cover(L) in opposite of Side Cover(R)
Separates by same method.
(RMC-KFA120T/170TDLX Models Only.)
-Remove 4 Screws along each side of heater
using medium phillips screwdriver. These
Screws attach Upper Rear and Lower shells
together. (See Figure 12)
(RMC-KFA65TDLX Model Only.)
-Remove Screws along each side of heater using
medium phillips screwdriver. These Screws
attach Upper and Lower shells together.
C.) AIR OUTPUT,AIR INTAKE AND
LINT FILTERS WASH AND DRY
WITH SOAP AND WATER OR
REPLACE EVERY 500 HOURS OF
OPERATION OR ONCE A YEAR.
-Remove Upper Shell.(See Figure 12)
-Remove Fan guard.(See Figure 13)
-Remove End Filter Cover Screws using
medium phillips screwdriver.
-Remove End Filter Cover.
-Replace Air Output and Lint Filters.
-Wash or Replace Air Intake Filter.
-Reinstall Fan Guard and Upper Shell.
10
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
9. MAINTENANCE
WARNING!! : NEVER SERVICE HEATER WHILE IT IS PLUGGED IN OR
WHILE HOT!
USE ORIGINAL EQUIPMENT REPLACEMENT PARTS. Use of third party or
other alternate components will void warranty and may cause unsafe operating
conditions.
Figure 12. Upper Shell Removal.
Figure 13. Air Output,Intake,and Lint Filters
9
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
8. LONG TERM STORAGE OF YOUR HEATER
FUEL TANK DRAIN
1. Remove Fuel Cap and Cap Fuel Filter(See Figure 10).
2. Drain Fuel Tank through Fuel Cap Opening and wash Fuel Cap Filter with clean fuel.
3.Using a small amount of kerosene,swirl and rinse the inside of the tank.
Never mix water with the kerosene as it will cause poor operation of the heater.
Pour the kerosene out making sure that you remove it all.
IMPORTANT : Do not store kerosene over summer months for use during next next heating season.
Using old fuel could damage heater.
4. Reinstall Fuel Cap Filter and Fuel Cap(See Figure 11).
IMPORTANT : Reinstall Fuel Cap Filter fully into Fuel Cap Opening on tank,
Otherwise it will not install completely.
5.Store heater in dry well ventilated area. Make sure storage place is free of dust and corrosive fumes.
6.Store the heater in the original box with the original packing material and keep the USER'S MANUAL
with the heater.
Figure 10. Remove Fuel Cap and Filter Figure 11. Reinstall Fuel Cap Filter