Filter
Top Products
TROUBLESHOOTING GUIDE
PROBLEMS
CAUSES
SOLUTION
THE FLAME PRODUCES
SMOKE, IN ANY POSITION
Door gasket is not selling
properly
1. Tighten door by turning
counter clockwise the door
handle.
2. Check if gasket needs to be
changed.
The burner orifices are plugged
up
1. Clean the burner with a
metallic brush.
Draught is too low 1. Make it checked by a
technician
FLAME GOES OUT TO
ITSELF
Oil level in the tank is too low
1. Fill up the tank.
Air pocket is stocked in the oil
line
1. Call a technician to the line
2. Make sure that the oil line
has an adequate slope
towards the tank.
Oil #2 is used in exterior tank 1. Use only oil #1 when tank is
installed outside.
Partial or total obstruction by
impurities in oil line or filters
1. Check filters on tank and
valve.
2. Ask a technician if the
cleanness of the tank and
line is OK.
THE STOVE MAKES NOISE,
GOES OUT AND LIGHT UP
AGAIN
The stove has been lit while
excess of oil was in the burner
1. Position the flow regulating
handle to 0.
2. Let the stove cool down.
3. Clean the burner if
necessary.
Note : Never light the stove
when the burner is full of oil.
Sponge the oil out before
lighting.
Page 12 of 15