Filter
Top Products
7
MODEL 3400 REMOTE FLUSH SWITCH INSTALLATION
3400 series toilets feature a remote flush switch to control the “Flush” and “Add Water” functions. Follow
the instructions below for switch installation.
STEP 1: Select a location for the switch. 8 feet of cable (2.4 m) is provided. You may need to supply more wire,
depending on how far you locate the switch from the
toilet.
STEP 2: Cut an opening 1-1/4” wide x 1-5/8” high (see
diagram at right).
STEP 3: If installing the switch in a shallow wall, you
may need to use the spacer between the wall and the
switch assembly cover to allow space for the wire con-
nectors. If so, route the cable through the spacer before
proceeding to the next step.
STEP 4: Route the 3-conductor cable through wall
cut-out and on to toilet. Cable can be routed with water
supply line and power wires (see page 5, Step 9). Leave
a minimum of 30 inches (.76m) of cable to allow easy
wiring at toilet.
STEP 5: Fasten the switch assembly to the wall with
the #6x1” screws (included), making sure to install with
the label “THIS SIDE UP” on top. Otherwise, the “Flush”
and “Add Water” functions will be reversed.
STEP 6: Snap cover onto switch assembly to complete
switch installation on wall.
STEP 7: WITH THE ELECTRICAL POWER OFF,
connect the red, black and white wires from the switch
to the red, black and white wires connected to the 11,
12 and 13 terminals on the control module. See page
6, Step 17 for other wiring procedure.
1-5/8 inch
(41 mm)
Cover
outline
Spacer
outline
REMOTE FLUSH SWITCH COMPONENTS
1-1/4 inch (32 mm)