Filter
Top Products
15
User Codes continued
User Code Authority Levels
System Options Standard Master
Sensor Reset ✔✔
Outputs On/Off ✔✔
Zone Monitor ✔✔
System Test ✔✔
Arm and Disarm ✔✔
Display Events ✔✔
User Codes ✔
Adding User Code Numbers:
1. Access the User Menu.
2. Press the COMMAND key until USER CODES? displays.
3. Press any one of the SELECT keys. The keypad displays ADD
DEL CHG.
4. Press the SELECT key under ADD to add a new user code. You
must have a Master user code level to be able to add a user code
to the system.
5. At the USER NUMBER: - prompt, enter a user number and
press COMMAND. The displays changes to CODE NO: .
6. Enter a user code number of 4 digits and press COMMAND. This
is the number they will use each time they arm, disarm, or make
changes to the system.
7. The display changes to MASTER? NO YES. Select YES to
make this a Master code level with the authority to Add, Delete,
and Change user code information.
Selecting NO
displays TEMP CODE NO YES.
Master code levels do not display TEMP CODE.
• NO makes this a permanent user code with Standard authority.
• YES makes this a temporary code with Standard authority that
automatically expires in 7 days. Temporary codes are perfect for
guests or service technicians. You can delete a Temporary user
code at any time before the 7 days expires.
8. After making your selection, the display shows USER # ADDED.
9. Press the ARROW key once to add another user or twice to exit
from the User Menu.
Ambush Codes
Your system may be programmed to allow user number 1 to be an
Ambush code. This Ambush code functions identically to other codes
with the exception that it sends a silent alarm to the central station.
This silent alarm alerts the operator to a duress situation at the
premises and prompts the immediate notification of the proper
authorities.
Refer to the System Setup section of this guide to see if your system
is programmed for Ambush. If so, do NOT program a code for user
number 1 unless you intend to use the Ambush function.
User Menu