Filter
Top Products
7
PAPER BAG REMOVAL & REPLACEMENT
NOTE: Unplug cleaner before changing paper bag. Cleaner must have paper bag in place at all times.
You can tell your bag needs replacing when you experience less suction when the *full bag indicator changes to yellow or if the clog indicator
light illuminates (see pg. 3). Do not exceed marked fill line on paper bag. Different types of dirt may require bag replaceme nt more often.
* FULL BAG INDICATOR When the full bag indicator window changes to yellow, it may be time for a new paper bag. Check the
paper bag, and if full, replace as described below. If not, the cleaner may have a clogged dirt passage (see “T rouble Shooting” pg. 9).
TO REMOVE OLD BAG
1. Pull release lever on front panel to remove front panel (Diagram 1). 2. REMOVE: Grasp cardboard collar of paper bag with both hands
and pull past raised locking tabs on the dirt tube (Diagram 2). Dispose of old paper bag.
TO INSTALL NEW BAG
IMPORTANT: Expand bag away from hole before installing (Diagram 3). Press in opening to clear paper away from hole. 1. Grip cardboard
collar and push past raised locking tabs on dirt tube with both hands (Diagram 4). 2. Fold bag inward about 3” from bottom to r est on top
of bag support posts (Diagram 5). Reattach front panel.
5.
1.
BAG TYPE:
U
RAISED
LOCKING
TABS
HOLE
RAISED
LOCKING
TABS
2. 3. 4.
1.
3.
External
Filter
Bag Chamber
Filter
(Internal Filter)
2.
*FRONT PANEL FILTER (external)
located on front panel. Filter should be
replaced once a year.
1. Remove filter cover by depressing
center tab (Diagram 3).
2. Remove and replace filter (Diagram 4).
*Not available on all models
4.
FILTER PADS REMOVAL & REPLACEMENT Unplug cleaner before changing filter.
This upright contains two filters: internal filter (Bag Chamber) and external filter (Front Panel). (Filter placement varies a ccording to
model) Diagram 2: filter placement is inside front panel. Diagram 4: filter placement is outside front panel. For filter repla cement call 1-
800-321-1134. External and bag chamber filter part # 3-863001-001. Front panel and bag chamber filter part # 3-865132-044.
BAG CHAMBER FILTER (internal)
located under paper bag. Filter should be
replaced after every third paper bag.
1. Remove front panel.
2.
Lift up on front edge and pull towards you
to remove (Diagram 1). Dispose of filter.
3.
Slide new filter pad into position.
4. Reattach front panel.
*EXTERNAL FILTER (external)
located on back of front panel. Filter
should be replaced after every third
paper bag.
1. Position filter to fit (Diagram 2).
2. Push over 6 posts.