Filter
Top Products
27
4 Filters
Emptying the dust container
G
1. Press the release buttons (Fig. 1/7) and open the
housing cover (Fig. 1/10).
2. Lift the dust container (Fig. 17/1) up out of the cylinder
vacuum cleaner.
3. When emptying the dust container, hold it low over a
dustbin.
4. Push the release button (Fig. 18/1). The base (Fig. 18/
2) opens and the dust runs into the dustbin.
5. Carefully knock the remaining dust loose.
6. Close the base.
7. Put the dust container back into the cylinder vacuum
cleaner and close the housing cover. It clicks audibly
into place.
4 Filters
The cylinder vacuum cleaner has the following filters:
- Central laminar filter (Fig. 19/1)
Is used to filter out the fine dust particles.
Clean: every 2 months
- Protective motor filter (Fig. 19/2)
If the central laminar filter is defective, it prevents
larger particles from destroying the motor.
Check: every 6 months
- Hygienic blow-out filter (Fig. 19/3)
Filters out the fine particles from the blow-out air.
Replace: every 6 months
The filters can become blocked after some time and can
thereby reduce the suction power. It is therefore important
that the abovementioned intervals are adhered to.
If you determine that a filter is damaged then replace it
immediately.
Fig.17
1
Fig.18
2
1
ATTENTION:
The filters are not suitable for machine washing.
Fig.19
1
2
3
02Centrixx_Retro_gb.book Seite 27 Freitag, 23. Februar 2007 11:28 11