Filter
Top Products
9
HOSE AND TOOL USAGE
Remove the hose from hose
caddy.
Choose any of the handy accessories
or use the hose alone.
Simply push the attachment
firmly onto the hose end. To
remove tool, twist and pull
apart gently.
1.
2.
TO USE HOSE AND ATTACHMENTS
3.
CAUTION: Do not lift unit from floor to use hose, loose items may become entangled in the rotating brushroll
BELT OR BRUSHROLL REMOVAL & REPLACEMENT: CONTINUED
Slide belt onto motor shaft. Place new belt in area of
brushroll without bristles.
4.
5.
TO REPLACE BELT OR BRUSHROLL
6.
With new belt in place, pull and slide
brushroll into nozzle making sure that
the brushroll end cap on the right side is
in the correct orientation (6a inset).
Rotate brushroll manually to make sure
belt is properly aligned.
Flip cleaner back over and replace
all six (6) screws.
Reattach nozzle guard by
firmly pushing down until it
snaps into place.
7.
8.
6a.
MOTOR SHAFT
END CAP
WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
®
Dealer or visit
our website at www.dirtdevil.com. Costs of any transportation to and from any place of repair are to be paid by the
owner. The service parts used in this unit are easily replaced and readily available from an authorized Royal
®
Dealer or
retailer. Always identify your cleaner by the model number and manufacturing code when requesting information or
ordering replacement parts. (The model number appears on the bottom of the cleaner.)
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
Cleaner won’t run
Cleaner won’t
pick-up or low
suction
Dust escaping
from cleaner
1. Power cord not firmly plugged into
outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
4. Thermal Protector activated.
1. Dirt container not installed correctly.
2. Dirt container full.
3. Brushroll worn.
4. Broken or worn belt.
5. Clogged filter.
6. Nozzle/brushroll clogged.
7. Hose clogged.
1. Dirt container full.
2. Dirt container not installed correctly.
3. Hose not installed correctly.
4. Filter not installed completely.
TROUBLESHOOTING GUIDE
1. Plug unit in firmly.
2
. Check fuse or breaker in home. Replace
fuse/reset breaker.
3. Take to service center.To find nearest location,
visit our website at www.dirtdevil.com or call
1-800-321-1134.
4. Unplug cleaner - allow to cool.
1. Review dirt container removal & replacement -
Pg. 7, 8.
2. Empty dirt container - Pg. 7.
3. Replace brushroll - Pg. 8, 9.
4. Replace belt - Pg. 8, 9.
5. Remove filter and clean - Pg. 7, 8.
6. Check nozzle/brushroll; remove obstruction/clog -
Pg. 8, 9.
7. Remove hose; remove clog - Pg. 6.
1. Empty dirt container - Pg. 7.
2. Review dirt container removal & replacement -
Pg. 7, 8.
3. Review hose installation - Pg. 6.
4. Review filter removal & replacement - Pg. 7, 8.
10