Filter
Top Products
4. To mount the unit (excluding EWMSC-ESP,EWMSC-W)
so that the wall outlet is hidden, mount the bracket 30”- 33”
above the top of the outlet. (FIGURE 3)
5. Use a stud locator to determine the location of
the studs in the corner.
6. Mark the stud locations on the wall.
7. Position mounting brackets on wall and align
with wall stud markings.
NOTE
Ensure that each mounting bracket is installed into
at least one wall stud.
NOTE
When installing into one wall stud use one of the
center locations as indicated in FIGURE 6.
NOTE
When installing into two wall studs use the outer
locations as indicated in FIGURE 7.
8. Choose the center marking and place the bubble
level onto the top of the wall mounting bracket.
9. Adjust the wall-mounting bracket so the
bubble on the level is centered between the two
black lines.
10. Mark the other two mounting screw locations
on the wall bracket ensuring that the wall bracket
stays level.
11. Drill 1/4” holes into the wall on the marked
locations where wall anchors are to be installed.
(FIGURE 4)
NOTE
Do not drill 1/4” holes into the wall where the studs have
been located.
12.Insert plastic wall anchor into 1/4” holes.
13.Insert the wall anchor screws through the wall
bracket and thread into the wall anchor. (FIGURE 5)
14. Install the remaining screw(s) into the wall
stud(s) as required.
15. Repeat steps 8 to 14 for 2
nd
bracket.
4
FIGURE 3
FIGURE 4
FIGURE 5
1/4” hole
Wall Anchor
Screw
1/4” hole
in wall
insert
plastic
anchor
Wall
Bracket