Filter
Top Products
SECURING DECORATIVE BOTTOM PANEL TO UNIT
NOTE
Secure decorative bottom panel to unit after installing unit to wall.
1. Fasten left and right brackets to lower moulding assembly.
2. Start 4 screws in the base unit, (do not fully fasten).
3. Fit the keyhole slots over the screws and fasten
the lower moulding in place.
4. Align decorative bottom panel to bottom of unit.
NOTE
Mantel instructions for EWMSC-W or EWMSC-ESP included with mantel.
SECURING FRONT DOOR TO UNIT
Locate the two door hinges, and fit them into their position on the back of the door. The cup-
shaped component fits into the large circular cutout on the back of the door. Position each of
the hinges as shown in the illustration below, and fasten the two mounting screws into place.
Lift the door into position on the fireplace. Slip the hinge into the front of the mounting plate
(see illustration below – action 1). Rotate the hinge with a light finger pressure to click the
hinge arm into position on the mounting plate (action 2). To undo this connection, press the
button on the end of the hinge, and rotate the hinge out of position.
FIGURE 10
Bottom
Panel
Bottom Panel Brackets
7