Filter
Top Products
OPERATION
The controls are located on the lower right side of the wall mounted electric fireplace.
(FIGURE 7)
A. MAIN ON/OFF SWITCH
The switch has two ON positions marked with and “Manual”.
The “Manual“ position is for manual operation. In this position the built-in remote control is by-
passed.
The
position is for operating the unit with the provided remote control.
When in
position the unit is operated with the ON and OFF buttons of the remote control.
When the switch is in the center position the unit is off.
B. HEATER ON SWITCH
The HEAT ON/OFF SWITCH supplies power to the heater fan and the heater element.
When the switch is in the ON position the heater operates if the thermostate calls for heat.
C. HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements, turn the thermostat control
clockwise all the way to turn on the heater. When the room reaches the desired
temperature, turn the thermostat knob counter clockwise until you hear a click. Leave in
this position to maintain the room temperature at this setting. For additional heat, turn
clockwise until you hear the click again and the heater will turn on.
NOTE: When the heater is switched ON, the heater fan will operate. The heater element may
or may not be on, depending on the thermostat control setting (SEE “HEATER THERMOSTAT
CONTROL”).
FIGURE 7 (LOWER RIGHT SIDE)
6
A
B
C