Filter
Top Products
8
MAINTENANCE
WARNING
Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire,
electric shock or damage to persons.
LIGHT BULB REPLACEMENT
WARNING
Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental
burning of skin.
Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity
and detail of the log exterior disappears. There are two bulbs under the log set which generate
the flames and embers.
Tool Requirements: Slot Screw Driver
NOTE
Before replacing lamps unnecessarily, ensure that they are not simply loose or that the
brightness control is not adjusted to low setting (see item D in operation section).
To open the light bulb area:
1. Remove the trim by pulling straight forward.
2. Hold the glass in place while removing the retaining clip from the upper center of the
firebox.
3. Lift glass out and store in a safe place.
CAUTION
Even though the glass is safety glass it may break if bumped, struck or dropped. Care must
be taken when handling the glass.
HELPFUL HINTS
It is a good idea to replace all light bulbs at one time if they are close to the end of their rated
life. Group replacement will reduce the number of times you need to open the unit to replace
light bulbs.