Filter
Top Products
7
Stove Installation
!
NOTE: A 15amp, 120 volt
alternating current (VAC) circuit
is required. A dedicated circuit is
preferred but not essential in all
cases. A dedicated circuit will be
required if, after installation, the
circuit breaker trips or fuse blows
on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord
is stored or secured to avoid
tripping or snagging to reduce the
risk of re, electric shock or injury
to persons.
WARNING:Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of re, electric
shock and injury to persons.
WARNING:Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
Make sure the units Main On/1.
Off switch is switched Off
(refer to operating instruction
section).
Plug the unit directly into a 15 2.
Amp/120 Volt outlet.