Filter
Top Products
FIREPLACE INSTALLATION
1. Make sure the units MAIN ON/OFF switch is
switched OFF (refer to operating instruction
section).
2. Plug the unit into a 15Amp/120VAC outlet. If
the cord does not reach, you may use an
extension cord rated for a minimum of 1875
watts.
OPERATION - see Fig. 2
Three switches provide a choice of heat settings. A
switch is in the ON position when the side with the
markings on
(i.e. I, I, or II) is pushed in.
Switch 1 (I) Controls the electricity supply to the
heater and flame effect.
Note: This switch must be in the ON
(I) position for heater to operate with
or without heat.
Switch 2 (I) Provides 715 W heat output.
Switch 3 (II) Provides 1430 W heat output with
switch 2.
3
I
II
II
FIG. 2
6
375
920
857
36.25
33.75
14.75
2
I
II
1
I
II