Filter
Top Products
www.desatech.com
114370-01E10
OPERATION
3. Wait ve (5) minutes to clear out any gas.
If you then smell gas, STOP! Follow "A"
in the safety information, column 1. If you
don't smell gas, go on the next step.
4. Light a match and lay it on top of pan
material about 2" from end of supply side
of pan.
5. Slowly turn gas shutoff valve ON until the
burner ignites. If burner does not ignite
within 10 seconds with the match burning,
turn shutoff valve OFF and repeat steps 1
through 4 again.
GAS SHUTOFF
VALVE OPERATION
Adjust ame ON/OFF by turning gas shutoff
valve counterclockwise to open and
clockwise to close as necessary.
Turn gas shutoff valve clockwise to
OFF position (see Figure 5, page 8).
CURING
LOGS
During the 2-3 hour appliance break in period,
you may detect an odor from appliance as
the various paints and compounds used in
the manufacturing of this log set cure. This is
a normal and temporary situation that is not
cause for alarm. However, you may want to
provide extra ventilation to the room during
this time.
To ensure proper curing of logs:
• Ignite a 2" ame and maintain for 1 hour
• Burn logs in consecutive 1 hour periods
raising ame an additional 2" to full height
for a total of 3 hours.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
-
WHAT TO DO IF YOU SMELL GAS
• Do not touch any electric switch; do
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information,
above.
2. Turn gas shutoff valve to OFF.
CLEANING AND MAINTENANCE
• Keep area around log set clean and clear
of debris.
• Occasionally use a soft bristle brush to
clean logs.
• Once every year a qualied agency or certi-
ed chimney sweep should examine and
clean the venting system of the replace.