Desa W32WP Indoor Fireplace User Manual


  Open as PDF
of 8
 
2701 Industrial Drive
P.O.Box90004
BowlingGreen,KY42102-9004
Technical Service and Parts: 1-866-672-6040
O
F
F
P
I
L
O
T
O
N
H
I
L
O
Figure 12 - Attaching Fireplace to Mantel and Mantel Base
Hole for 3" Screw for Attaching
Fireplace System to Wooden
Mantel Base
Bottom
Louver
Door
Figure 13 - Screw Locations for Fireboxes with Fixed Louver
Screws
Holes are Behind Louver on
Firebox Bottom for Attaching
Firebox to Wooden Mantel Base.
Fixed
Louver
Figure 11 - Inserting Fireplace Into Cabinet Mantel
Shoulder
Screw
Assembled
Trim
ASSEMBLING METAL TRIM INCLUDED WITH
GAS FIREPLACE
1. Remove packaging from three pieces of metal trim.
2. Locate two adjusting plates with set screws, and two shims
in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 10.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 10).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 10).
6. Whilermlyholdingedgesoftrimtogether,tightenbothset
screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 2 through 6 for other corner.
4. Positionreboxinsidemantel,carefullypositioninggas
lines. IMPORTANT:Usecautionwhenpositioningreplace
on base. Base may scratch easily.
5. Place trim kit on the shoulder screws located on the
sideandtopofthereplace.Firmlysnapthetrimover
theshoulderscrewsonreplace(seeFigure11).Align
replaceinmantelassemblysothatthetrimoverlapsthe
mantel evenly on all three sides.
6. Firebox with louver door: Lower bottom louver door.
Use two 3" screws provided in hardware package and
attachreplace/boxtowooden base(see Figure 12).
Close louver door.
Firebox with xed louver: Before installing logs or burner
assembly(seeowner'smanual)removescrewssecuring
oortoassembly.Liftoorforaccesstobottomofrebox.
Usetwo3"screwsprovidedinreplacehardwarepackage
andattachreplacebasetowoodenbase(seeFigure13).
Reinstalloorwithscrewsremovedpreviously.
Figure 10 - Assembling Metal Trim
Side Trim
Slot
Top Trim
Mitered Edge
Shim
Set Screws
Adjusting
Plate
Slot
119939-01
Rev. A
07/06
INSTALLING FIREPLACE
1. Fireplace should be fully assembled. See Assembling
Fireplaceinreplaceowner’smanual.
2. Install gas line. See Connecting To Gas Supplyinreplace
owner’s manual. Remember to leave access to the gas
shutoff valve somewhere on the base or where it is ac-
cessible to the user.
3. Check for leaks. See Checking Gas Connectionsinre-
place owner’s manual.
 previous next