Desa W32KCSA Indoor Fireplace User Manual


  Open as PDF
of 6
 
www.desatech.com
119794-01A
5
Figure 14 - Attaching Fireplace to Mantel and Mantel Base
Hole for Attaching
Fireplace System to
Wooden Mantel Base
Bottom
Louver Door
Figure 15 - Screw Locations for Fireboxes with Fixed Louver
Screws
Holes are Behind Louver on
Firebox Bottom for Attaching
Firebox to Wooden Mantel Base.
Fixed
Louver
Figure 16 - Fireplace, Metal Trim Assembly, Mantel, and
Mantel Base
Assembled
Metal Trim
Mantel
Base
(Side view
for clarity)
Shoulder
Screws
Shoulder
Screw
6. Fireplace with louver door: Lower bottom louver door.
Use two screws provided in hardware package and attach
replacetowoodenbase(seeFigure14).Closelouver
door
Fireplace with xed louver: Before installing logs or
burnerassembly(seeowner’smanual)removescrews
securingoortoassembly.Liftoorforaccesstobot-
tomofreplace.Usetwoscrewsprovidedinreplace
hardwarepackageandattachreplacebasetowooden
base(seeFigure15).Reinstalloorwithscrewsremoved
previously.
7. Place metal trim on shoulder screws. Firmly snap trim
assemblyovershoulderscrewsonreplace.
8. Carefully push mantel and base into position against wall.
Installing Fireplace without Flange
1. Place mantel assembly on wood base and center left to
righthavingbackofassemblyushwithbackofbase.
2. Attach mantel to base using 1
1
/
4
" screws through pocket
holes. Using brackets and 1/2" or 3/4" screws from bracket
hardware kit, attach brackets to base and mantel assembly
using one bracket at each back corner of leg sides and
one on each leg front (see Figure 13, page 4).
3. Positionreplaceinsidemantel(seeFigure16).Care-
fully position gas lines. IMPORTANT: Use caution when
positioningreplaceonbase.Basemayscratcheasily.
4. Fireplace with louver door: Lower bottom louver door.
Use two screws provided in hardware package and attach
replacetowoodenbase(seeFigure14).Closelouver
door
Fireplace with xed louver: Before installing logs or
burnerassembly(seeowner’smanual)removescrews
securingoortoassembly.Liftoorforaccesstobot-
tomofreplace.Usetwoscrewsprovidedinreplace
hardwarepackageandattachreplacebasetowooden
base(seeFigure15).Reinstalloorwithscrewsremoved
previously.
5. Place metal trim on shoulder screws. Firmly snap trim
assemblyovershoulderscrewsonreplace.
6. Carefully push mantel and base into position against wall.
 previous