Desa W32KCSA Indoor Fireplace User Manual


  Open as PDF
of 6
 
www.desatech.com
119794-01A
4
ASSEMBLING METAL TRIM
1. Remove packaging from three pieces of metal trim.
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 11.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 11).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 11).
6. Whilermlyholdingedgesoftrimtogether,tightenbothset
screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 2 through 6 for other corner.
Figure 11 - Assembling Metal Trim
Side Trim
Slot
Top Trim
Mitered Edge
Shim
Set Screws
Adjusting
Plate
Slot
FIREPLACE INSTALLATION
1. Fireplace should be fully assembled. See Assembling
Fireplaceinreplaceowner’smanual.
2. Placemantelbaseclosetoinstallationlocation.Seere-
placeowner’smanualforinstallationclearances.Leave
enoughroomtogetbehindmanteloncereplaceand
mantel assembly have been attached to base if installing
areplacewithange.
3. Install gas line. See Connecting to Gas Supplyinreplace
owner’smanual.Remembertoleaveaccesstothegas
shutoff valve somewhere on the base or where it is ac-
cessible to the user.
4. Check for leaks. See Checking Gas Connectionsinre-
placeowner’smanual.
IMPORTANT:IfyourreplacehasanailingangeseeInstalling
Fireplace with Flange.Ifyourreplacedoesnothaveanailing
angesee Installing Fireplace without Flange, page 5.
Installing Fireplace with Flange
1. Place mantel assembly on wood base and center left to
righthavingbackofassemblyushwithbackofbase.
Mark placement on base along inside front of mantel
assembly. Remove mantel assembly from base.
2.
Positionreplaceonbase,centeringlefttorightbetweenmark-
ings. Carefully position gas lines. IMPORTANT: Use caution
whenpositioningreplaceonbaseasbasemayscratch.
3. Withassistance,carefullyplacemanteloverreplace
(seeFigure12).Fireplacenailingangeswillbetoinside
of mantel. Align mantel with markings made previously.
Makesurebackofmantelisushwithbackofmantel
base.Adjustreplaceasnecessary.
4. Attach mantel to base using 1
1
/
4
" screws through pocket
holes. Using brackets and 1/2" or 3/4" screws from
bracket hardware kit, attach brackets to base and mantel
assembly using one bracket at each back corner of leg
sides and one on each leg front (see Figure 13).
5. Adjustreplacesothatittsintomantelopeningproperly.
Figure 12 - Installing Fireplace with Flange
Assembled
Metal Trim
Mantel Base
(Side view
for clarity)
Shoulder
Screws
Gas Line
Access Hole
Possible
Shutoff Valve
Locations
Screw
Shoulder
Screw
Figure 13 - Installing Brackets to Mantel Base
Bracket with
1/2"-3/4"
Screws
Mantel Base
Bracket with
1/2"-3/4"
Screws
 previous next