Filter
Top Products
www.desatech.com
121868-01B
3
Top
Leg
Assemblies
1
1
/
4
" Screw
Figure 5 - Attaching Top to Leg and Header Assembly
1. Place mantel top (#7) onto upright leg assembly (see
Figure 5). Align back of top with back of sides.
2. Using three
1
1
⁄4" screws with washers, attach top to
header/leg assembly (see Figure 5).
Washer
Back of Top
Flush with
Back of Leg
Assembly
ATTACHING MANTEL TO BASE
Attach mantel to base using 4 brackets and 1/2" screws, 2 per
leg assembly, into threaded holes in base and leg assembly
(see Figure 6).
1. Fireplace should be fully assembled. See Assembling
Fireplace in replace owner’s manual.
2. Place mantel base close to installation location. See
replace owner’s manual for installation clearances.
3. Mantel must be installed flush with wall. Remove
baseboard along wall where mantel is to be installed.
Baseboard will prevent proper installation of mantel and
base.
4. If installing gas replace, install gas line. See Connecting
to Gas Supply in replace owner’s manual. Remember
to leave access to the gas shutoff valve somewhere on
the base or where it is accessible to the user. Check
for leaks. See Checking Gas Connections in replace
owner’s manual.
5. Position replace inside mantel through front opening.
Carefully position gas lines if applicable. IMPORTANT:
Use caution when positioning replace on base. Base
may scratch easily. Make sure replace is in proper po-
sition within the mantel opening before continuing with
installation.
This mantel can be used with DESA Heating, LLC 23" Electric
Fireplace. Electric replaces install from the front of mantel.
To install electric replace see replace instruction manual.
Use caution when positioning replace on base. Base may
scratch easily.
Figure 6 - Attaching Mantel Assembly to Mantel Base
Bracket with 1/2"
Screws