Filter
Top Products
www.desatech.com
121868-01B
2
Figure 3 - Installing Header
Left Leg
Assembly
Right Leg
Assembly
Header
Shoulder
Figure 2 - Attaching Front Leg
Figure 4 - Attaching Header to Leg Assembly
Header Assembly
Block #8
Header
Leg
Assembly
1
1
/
4
" Screw
Brackets
Right Side
Figure 1 - Attaching Brackets to Side
1. Lay right side panel (#2) face down on a soft surface
to avoid marking nish. Attach three brackets with 1/2"
screws to bottom of right front leg (#3) leaving screws
slightly loose. Face brackets out (see Figure 1). Place
right front leg (#3) over right side (#2) as shown in Figure
2, paying close attention to direction arrow pointing up on
panels. Align threaded holes with brackets on side. Start
three 1/2" screws through brackets. Align bottom of side
and leg assembly so they are ush with each other. Hold
these pieces securely in alignment while tightening (but
not over tightening) screws.
2. Assemble left side (#4) and left leg (#5) as described in
step 1.
3. You may prefer to lay mantel face down on a soft surface
instead of upright to position header. Position header (#6)
between leg assemblies with direction arrow pointing up
(see Figure 3). Attach header assembly blocks (#8) with
1
1
⁄4" screws and washers (see Figure 4).
1/2" Screws
Right Side
Right Front Leg
1/2" Screws
Washer