Filter
Top Products
111253-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
23
23
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Installing Logs, Lava Rock, and Glowing Embers
Figure 41- Installing Log No. 2
2
Figure 42 - Installing Log No. 3
3
2. Rest left side of log #2 (front log) onto top of log #1. Place
right side of log onto second pin located on right side of grate
(see Figure 41).
3. Place log #3 (rear log) onto pins on rear of grate as shown in
Figure 42.
4. Place log #4 (crossover log) onto pins from both logs #2 and
#3 as shown in Figure 43.
5. Place log #5 (top log) onto right pin of front log (#2) and the
smooth surface of crossover log (#4) as shown in Figure 44.
Make sure it is seated properly.
6. Place log #6 (left log) onto left pin of front log (#2) and the
smooth surface of rear log (#3) as shown in Figure 45. Make
sure it is seated properly.
8. Place lava rock along sides and front of firebox bottom in ar-
eas that are visible only. It is not necessary to use all of the
lava rock provided.
NOTICE: Do not put lava rock on burner or under
burner. Placing lava rock on burner will cause perfor-
mance problems.
9. Pull ember material apart into pieces no larger than a dime.
Place these pieces loosely and sparingly directly onto the ex-
posed section of the front burner and along the space between
the burner and grate prongs (see Figure 46). This will create
the glowing ember appearance as the flame touches the ember
material. Do not block air slots by using too much ember ma-
terial in one area. It is not necessary to use all of the ember
material provided.
10. Close glass door, lock door latches, replace screen, and close
louvers (see Removing/Replacing Glass Door, steps 5 through
7, page 21).
WARNING: The glass door must be securely in
place before running this fireplace. Do not run this
fireplace if glass is missing or broken.
Ember Material
Figure 46 - Placing Ember Material on Burner
Figure 44 - Installing Log No. 5
5
6
Figure 45 - Installing Log No. 6
Figure 43 - Installing Log No. 4
4