Filter
Top Products
www.desatech.com
114370-02C14
TROUBLESHOOTINg
POSSIBLE CAUSE REMEDY
OBSERVED PROBLEM
1. Control knob not fully
pressed in
2. Control knob not pressed in
long enough
3. Safety interlock system
has been triggered
4. Equipment shutoff valve not
fully open
5. Pilot flame not touching
thermocouple, which al-
lows thermocouple to cool,
causing pilot flame to go
out. This problem could be
caused by one or both of the
following:
A) Low gas pressure
B) Dirty or partially clogged
pilot
6. Thermocouple connection
loose at control valve
7. Thermocouple damaged
8. Control valve damaged
1. Inlet gas pressure is too low
2. Burner orice clogged
3. Mislocated crossover tube
4. Remote selector in OFF
position
5. Wire disconnected from gas
control
1. Manifold pressure is too
low
2. Burner orice clogged
3. Mislocated crossover tube
1. Burner orice is clogged or
damaged
2. Damaged burner
3. Gas regulator defective
Pilot lights but ame goes out
when control knob is released
One or both burner does not light
after ODS/pilot is lit
Delayed ignition of burner
Burner backring during com-
bustion
1. Press in control knob fully
2. After pilot lights, keep control
knob pressed in 30 seconds
3. Wait one minute for safety in-
terlock system to reset. Repeat
ignition operation
4. Fully open equipment shutoff
valve
5. A) Contact local natural or
propane/LP gas company
B) Clean pilot (see Cleaning
and Maintenance, page 13) or
replace pilot assembly
6. Hand tighten until snug, then
tighten 1/4 turn more
7. Replace pilot assembly
8. Replace control valve
1. Contact local natural or pro-
pane/LP gas company
2. Clean burner (see Cleaning
and Maintenance, page 12)
or replace burner orice
3. Contact qualified service
person
4. Put remote selector in ON
position
5. See Wiring Diagram, page 17
1. Contact local natural or pro-
pane/LP gas company
2. Clean burner (see Cleaning
and Maintenance, page 12)
or replace burner orice
3. Contact qualified service
person
1. Clean burner (see Cleaning
and Maintenance, page 12)
or replace burner orice
2. Replace damaged burner
3. Replace gas regulator