Filter
Top Products
111115-01D
14
For more information, visit www.desatech.com
For more information, visit www.desatech.com
OPERATING HEATER
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don’t try to repair it, call a qualified service techni-
cian or gas supplier. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
INSTALLATION
Continued
Figure 24 - Installing Log set (Top View)
Logs
Burner
Ports
O
F
F
P
I
L
O
T
O
N
H
I
L
O
O
F
F
P
I
L
O
T
O
N
H
I
L
O
O
F
F
P
I
L
O
T
O
N
H
I
L
O
O
F
F
P
I
L
O
T
O
N
H
I
L
O
Figure 25 - Installing Left Top
Log (#2)
Figure 26 - Installing Right
Top Logs (#3 and #4)
Right Rear
Log (#3)
Right Front
Log (#4)
INSTALLATION
Installing Logs (Cont.)
OPERATING HEATER
For Your Safety Read Before Lighting
Left Front
Log (#2)
2. Position left front log (#2) onto two pins on left front and middle
of base log (see Figure 25).
3. Place right rear log (#3) onto two pins on right rear of base log
(see Figure 26).
4. Place right front log (#4) onto two pins on right front of base
log (see Figure 26).
5. Place control cover log (#5) onto two pins in front right sec-
tion of base log. Be sure control cover log seats well into cut-
out section of base log (see Figure 27).
6. Place lava rock around base of heater.
Figure 27 - Control Cover Log (#5) Placement
O
F
F
P
I
L
O
T
O
N
H
I
L
O
O
F
F
P
I
L
O
T
O
N
H
I
L
O
Control Cover
Log (#5)