Filter
Top Products
23
103669
Thermocouple
Pilot Burner
Figure 25 - Incorrect Pilot Flame Pattern
If pilot flame pattern is incorrect, as shown in Figure 25
• turn fireplace off (see To Turn Off Gas to Appliance, page 22).
• see Troubleshooting, pages 24 through 27.
INSPECTING
BURNER
Continued
BURNER FLAME PATTERN
Figure 26 shows a correct burner flame pattern. Figure 27 shows an incorrect
burner flame pattern. The incorrect burner flame pattern shows the flame
consistantly higher than one inch above the log.
Note:
When using the fireplace the first time, the flame will be yellow for approxi-
mately one hour until the log cures.
If burner flame pattern is incorrect, as shown in Figure 27
• turn fireplace off (see To Turn Off Gas to Appliance, page 22).
• see Troubleshooting, pages 24 through 27.
Figure 26 - Correct Burner Flame Pattern
Figure 27 - Incorrect Burner Flame Pattern
CORRECT FLAME PATTERN
AT HIGH POSITION
INCORRECT FLAME PATTERN
AT HIGH POSITION
Top of
Flame
Consistantly
About One
Inch Higher
Than Logs
Top of
Flame
About One
Inch Below
Logs