Filter
Top Products
9
105704
OWNER’S MANUAL
OPERATING
FIREPLACE
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: If you do not fol-
low these instructions exactly, a
fire or explosion may result caus-
ing property damage, personal
injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all
around the appliance area for gas. Be
sure to smell next to the floor because
some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL
GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow
the gas supplier’s instructions.
• If you cannot reach your gas sup-
plier, call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn
by hand, don’t try to repair it, call a
qualified service technician or gas
supplier. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been un-
der water.
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information,
above.
2. Turn wall switch to the OFF position.
3. Turn off all electric power to the ap-
pliance.
4. Remove control access panel.
5. Turn gas control knob clockwise
Clockwise
to the OFF position.
6. Wait five (5) minutes to clear out any
gas. If you smell gas, STOP! Follow “B”
in the safety information. If you don’t
smell gas, go to the next step.
7. Find pilot. Follow metal tube from
gas control. The pilot is behind the
burner tube.
8. Turn control knob counterclockwise
C-clockwise
to the PILOT position.
9. Push in the knob all the way and hold
in. Immediately light the pilot by
pressing the red ignitor button. Con-
tinue to hold the control knob in for
about (1) minute after the pilot is lit.
Release button and it will pop back
up. Pilot should remain lit. If it goes
out, repeat steps 5 through 9.
• If button does not pop up when
released, stop and immediately
call your service technician or gas
supplier.
• If the pilot will not stay lit after sev-
eral tries, turn the gas control knob
to “OFF” and call your service
technician or gas supplier.
10. Turn gas control knob counterclock-
wise
C-clockwise
to “ON”. Knob can be
turned to “ON” only if the control
knob is popped out.
11. Replace control access panel.
12. Turn on all electric power to the ap-
pliance.
Figure 22 - Installing Log No. 2
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
INSTALLATION
Continued
2. Place log #2 (large front log) in
groove on firebox floor in front of
burner with log texture facing up and
out (see Figure 22).
3. Place lava rock along sides and front
of inside of firebox bottom. It is not
necessary to use all of the lava rock
provided.
Figure 23 - Control Knob in the PILOT
position
J
TH
TP
TP
TH
IN
PILOT ADJ
ON OFF
P
I
L
O
T
R
O
B
E
R
T
S
H
A
W
Position Indicator
Gas Control Knob
Continued