Filter
Top Products
110749-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
10
Figure 9 - Inserting Firebox Into Cabinet Mantel (Mantel May
Vary From Illustration)
INSTALLATION
Continued
WARNING: Do not allow any combustible materi-
als to overlap the firebox front facing.
IMPORTANT:
Noncombustible materials such as brick, tile, etc.
may overlap the front facing, but should never cover any necessary
openings like louvered slots.
WARNING: Do not allow noncombustible materials
to cover any necessary openings like louvered slots.
WARNING: Use only noncombustible mortar or
adhesives when overlapping the front facing with
noncombustible facing material.
This firebox may be installed using a cabinet mantel against a wall in
your home. The firebox and cabinet mantel can be installed directly
on the floor. Mantels may be available from your retailer or custom
built for your home.
WARNING: A qualified service person must in-
stall firebox. Follow all local codes.
INSTALLING FIREBOX USING OPTIONAL
MANTELS AVAILABLE FROM RETAILER OR
CUSTOM BUILT
Figure 7 - Attaching Firebox to Wall Studs
Nailing
Flanges
Nails or
Wood
Screws
Figure 8 - Installing Cabinet Mantel (Mantel May Vary From
Illustration)
Cabinet
Mantel
Gas Line
Access Hole
(Either Side
of Firebox)
Gas
Piping
INSTALLATION
Built-In Firebox Installation (Cont.)
Installing Firebox Using Optional Mantels Available from Retailer or Custom Built
IMPORTANT:
When finishing your firebox, combustible materials
such as wall board, gypsum board, sheet rock, drywall, plywood, etc.
may be butted up next to the sides and top of the firebox. Combustible
materials should never overlap the firebox front facing.
1. Assemble cabinet mantel as instructed.
2. Install gas piping to firebox location. See Installing Gas Line,
page 11. You may have to cut an access hole in the floor or
wall to run gas line to firebox. Make sure to locate access hole
so cabinet mantel will cover it when installed (see Figure 8).
3. Place firebox on floor in desired location. Make sure mantel
will be flush against wall when installed.
4. Carefully slide cabinet mantel over firebox. Be careful not to
scratch firebox, cabinet mantel, flooring, etc. when installing
(see Figure 9).
5. Install and properly test gas log heater. Follow installation in-
structions included with the vent-free gas log heater that is
being installed.