Filter
Top Products
110749-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
11
11
INSTALLATION
Installing Gas Line
Installing Fireplace Hood and Screen
INSTALLATION
Continued
INSTALLING GAS LINE
WARNING: A qualified service person must con-
nect heater to gas supply. Follow all local codes.
IMPORTANT:
See Connecting to Gas Supply in your log set
owner’s manual for details on gas hookup.
You may run the gas line from either side of the firebox (see
Figure 11). Decide which side you want to run the gas line from.
Note:
This is one option for installing shutoff valve. Check local
codes for equipment shutoff valve location requirements.
Locate the recessed knockout in one of the firebrick sidewall liners
(see Figures 10 and 11). Firmly tap the center of the knockout with
a chisel until it is released. Carefully chisel the rough edges of the
hole you have made to smooth edges. This hole will line up with the
hole in the outer casing.
Locate the recessed knockout in one of the firebrick sidewall liners (see
Figures 10 and 11). Firmly tap the center of the knockout with a chisel
until it is released. Carefully chisel the rough edges of the hole to
smooth edges. This hole will line up with the hole in the outer casing.
Figure 10 - Installing Gas Line and Equipment Shutoff Valve
(Model May Vary From Illustration)
Knockout Locations
(Knock Out One Hole)
Gas Line Hole
CAUTION: Do not use excessive force to remove
the knockout. Too much force may damage the fire-
brick concrete insert.
Equipment
Shutoff
Valves
(Install
One)
1
3
/
8
" Thick Liner
Figure 11 - Location of Knockout for Gas Line
Knockout
Chisel
Firebrick Side Wall
Remove
this Area
Side
View
INSTALLING FIREPLACE HOOD AND SCREEN
1. Attach hood to firebox using screws provided (see Figure 12).
2. Insert each rod through all rings located at top of screen.
3. Insert first rod into rear hole in left side of firebox. Fasten rod
to rear hole near center of firebox using #10 x 3/8" Phillips
screw provided (see Figure 13).
4. Insert other rod into front hole on right side of firebox and
fasten using remaining Phillips screw.
Figure 12 - Screw and Hood Placement
Screws
Figure 13 - Installing Fireplace Screen
Screw
Rear Hole
Top View of
Rod Layout
Rod
Front Hole
Ring
Screen