Filter
Top Products
17
101047
INSTALLATION
Continued
Mounting Heater to Optional Hearth Base
1. Lay heater on its back on a table with the bottom of heater overhanging the edge
of the table.
2. Remove 2 shipping screws in bottom of heater. Discard shipping screws.
3. Line up mounting holes on top of hearth base with holes in bottom of heater (see
Figure 18).
4. Using a Phillips screwdriver, secure hearth base to heater with four sheet metal
screws (see Figure 18).
Continued
Base
Bottom of Heater
Shipping
Screw
Laminate
Sheet
Hearth
Insert
Figure 19 - Placing Hearth Insert on Heater Base
and Attaching Brass Base Trim
Screw
Brass Base
Trim
Mounting Holes
Sheet Metal
Screw
Holes for Securing
Heater to Floor
Figure 18 - Attaching Heater to Hearth Base
5. Stand heater up on base.
6. Slide laminate sheet into hearth insert. Place hearth insert on front of hearth base
as shown in Figure 19 below.
7. Assemble brass trim (see steps 1 through 7 under Assembling and Attaching
Brass Trim, page 7).
8. Slide base trim on heater base. Attach brass trim to base with two brass screws
included as shown in Figure 19 below.