Filter
Top Products
13
104256
OWNER’S MANUAL
INSTALLATION
Continued
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this heater may result in
property damage or personal in-
jury.
INSTALLING LOGS
For Vintage Oak Model
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Locate pegs on the bottom of back log
(#1). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 17).
2. Locate the notches on the back of the
front log (#2). Slide these notches over
the tabs of the grate base (see Figure
18).
3. Locate the notches in the bottom of the
crossover log (#3). Place the crossover
log on top of the back log and front log.
Make sure the notches of the crossover
log line up with rectangular knobs on
top of the back and front logs (see Fig-
ure 19).
4. Add lava rock around base of heater.
Figure 17 - Installing Back Log
Back Log
(#1)
Crossover
Log (#3)
Figure 19 - Installing Crossover Log
Figure 18 - Installing Front Log
Front
Log (#2)
Notch
Peg
Notch
Rectangular
Knob
Notch
Peg
Tabs of
Grate Base
Hole
Rectangular
Knob
For Golden Oak or Birch Models
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place one-piece log set on grate to fit
as illustrated in Figure 20. Make sure
middle section at bottom of log set is
seated into “U”-shaped cutout in cen-
ter of chassis (see Figure 20).
Note:
36”
model has more features but fits on the
chassis the same. Log will fit securely
on chassis.
IMPORTANT:
Make sure
log does not cover any burner parts.
2. Place lava rock around base of heater.
Figure 20 - Installing Golden Oak or Birch
One-Piece Log Set
Figure 21 - Installing Golden Oak or Birch
One-Piece Log Set (Top View)
One-Piece
Log Set
Middle
Section
at
Bottom
of Log
Set
Burner
“U”-shaped Cutout
in Chassis
Chassis
Burner
One-Piece
Log Set