Filter
Top Products
12
103427
UNVENTED PROPANE GAS LOG HEATER
Figure 22 - Installing Front Logs
(#1L and #1R)
Grate
Prongs
Metal Grate Bar
Front Log (#1L)
Notch
Front Log (#1R)
Right Front
Branch (#5)
Notches
Left Front Branch (#4)
(24" & 30" models)
or Front Branch (#4)
(18" Model)
Notches
INSTALLATION
Continued
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this heater may result in
property damage or personal in-
jury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Slide rear log (#1) into place behind
rear burner (see Figure 18).
2. Slide front log (#2) into place behind
front burner. Make sure tabs at bottom
of log are behind front burner (see Fig-
ure 19).
3. Place crossover log (#3) into place (see
Figure 20). Be sure to place back of
crossover log into notch on left side of
rear log. The indentation under front
right fork of crossover log must rest on
rectangular knob of front log.
4. Place left front branch (#4) and right
front branch (#5) (24" and 30" mod-
els) or front branch (#4) (18" model)
into place (see Figure 21). Make sure
notches on bottom rest on grates.
5. Add lava rock around base of heater.
INSTALLING LOGS
(American Oak Design
Models)
Figure 18 - Installing Rear Log
Rear Log
(#1)
Crossover
Log (#3)
Figure 20 - Installing Crossover Log
Figure 21 - Installing Left Front Branch
and Right Front Branch
Figure 19 - Installing Front Log
Tab
Front Log
(#2)
Continued