Filter
Top Products
112126-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
7
7
12. Check general catch bolt alignment with door claw. Make fi-
nal adjustment and door leveling after stove is in normal stand-
ing position.
13. Carefully lift stove back up on its four attached legs.
Removing Front Surround Panel
Remove 2 bolts from bottom of stove and set aside. Remove bolt from
the top of the stove to remove the front panel assembly (see Figure 13).
CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
Continued
Figure 13 - Removing Front Assembly (Oxford™ Model Shown)
Front
Assembly
Bolt
Stove
Body
CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
Stove Body Assembly (Cont.)
Installing Direct-Vent Burner System Into Stove Body
Removing Screen (Optional)
Amity Models
1. Lay the front panel assembly face down on a protected sur-
face. Remove the two screws that hold the front plate onto the
front surround plate (see Figure 14). Save these screws.
2. Remove the screws and washers that hold the screen onto the
front surround plate. Discard these screws, washers, and screen
(see Figure 14).
3. Replace the two screws from step 1 to reassemble the front
plate and the front surround plate. Set this assembly aside un-
til burner system has been installed, logs have been placed
inside of burner system, and glass door to burner system insert
has been replaced.
Oxford or Victor Hearth Models
1. Lay the front panel assembly face down on a protected sur-
face. Remove the screws and washers that hold the screen onto
the front surround plate. Discard these screws, washers, and
screen (see Figure 14).
2. Set this assembly aside until burner system has been installed,
logs have been placed inside of burner system, and glass door
to burner system insert has been replaced.
Figure 14 - Removing Screen from Front Assembly
Screws
Front
Surround
Plate
Front Plate
Screen
Screw with
Washer
Amity™ Model
Oxford™ and Victor Hearth™
Model
Screw with
Washer
Screen
Front Surround
Plate and
Doors
L
O
H
I
P
I
L
O
T
O
FF
O
N
INSTALLING DIRECT-VENT BURNER
SYSTEM INTO STOVE BODY
1. Carefully lift burner system and place into stove body from
the rear of stove.
2. Place the left and right grate tops into the top of stove body. Dis-
card center grate top of stove and replace with center grate top
provided with burner system.
Figure 15 - Installing Burner System Into Cast Iron Stove Body
Cast Iron
Stove Body
Burner
System
Right Top
Grate
Center Top Grate
(Included with
Burner System)
Left Top
Grate