Filter
Top Products
12
104025
INSTALLING
Continued
10. Attach stove door by inserting step bolt through door hinge pivot hole and into
threaded hole in stove body (see Figure 8 and 11). Use an adjustable wrench or a
12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door
moves freely.
Figure 11 - Attaching Stove Door
Step
Bolt
Door
Hinge
Threaded
Hole
Stove
Door
Stove Bottom
Bolt
Shoulder
Door
Hinge
Step
Bolt
Bolt
Shoulder
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded
hole on stove body (see Figure 8, page 10). Use an adjustable wrench or a
12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12).
The top nut is a bolt stop and the bottom nut is for door leveling adjustment.
12. Check general catch bolt alignment with door claw. Make final adjustment and
door leveling after stove is in normal standing position.
13. Carefully lift stove back up on its four attached legs.
14. Set top grate into stove top.
15. If available, install gas log heater inside stove cavity before installing the back
panel (see Installing Gas Log Heater Into Stove page 13).
16. Fasten back panel to stove with six (6) M6 x 1 - 20mm bolts and washers. Make
sure product identification label is located on the outside in lower left-hand
corner.
Adjusting Nut
Bolt Stop
Catch Bolt
Door Claw
Door
Figure 12 - Catch Bolt and Door Claw Orientation
Stove
Door