Filter
Top Products
13
Nozzle
1. Remove upper shell (see
page 10).
2. Remove fan (see page 10).
3. Remove spark plug wire
from spark plug.
4. Remove spark plug from
burner head using 13/16"
open-end wrench.
5. Loosen flare nut using
3/4" open-end wrench.
Push fuel tube down.
6. Remove air line hose from
burner head.
7. Remove three (3) screws
using 5/16" nut-driver and
remove burner head from
combustion chamber.
8. Place burner head into vise
and lightly tighten.
9. Carefully remove nozzle
from burner head using
5/8" socket wrench (see
Figure 16).
10. Blow compressed air
through face of nozzle.
This will free any dirt in
nozzle area.
11. Inspect nozzle sleeve for
damage.
12. Replace nozzle into burner
head. Tighten nozzle
firmly (80-110 inch-
pounds/9.1-12.4 n-m).
13. Attach burner head to
combustion chamber.
14. Install spark plug in burner
head.
15. Attach spark plug wire to
spark plug.
16. Attach fuel tube and airline
hose to burner head.
Attach flare nut until nut
seats against fuel tube and
fitting. Tighten 1/4 turn
more using 3/4" open-end
wrench (100-130 inch-
pounds/11.3-14.7 n-m).
17. Replace fan (see page 10).
18. Replace fan guard and
upper shell.
Figure 15 - Removing Burner Head
Figure 16 - Removing Nozzle
Nozzle
Face
Nozzle
Burner
Head
Nozzle
Sleeve
Spark
Plug
Combustion
Chamber
Fuel Tube
Flare Nut
Burner Head
Air Line Hose
Screw
Spark Plug
Wire