Desa NZ119 Electric Heater User Manual


 
www.desatech.com
11118621-01B
MOUNTING HEATER TO FLOOR
WITH OPTIONAL FLOOR KIT
Mounting Base Feet to Heater
1. Lay heater cabinet on its back on a table
with the heater bottom overhanging the
table edge.
2. Align holes in base foot with mounting holes
on bottom of cabinet (see Figure 12).
3. Secure base foot to heater using sheet
metal screws.
4. Repeat for other side.
INSTALLATION
Continued
R
E
M
OT
E
OF
F
Battery Cover
Receiver
Figure 13 - Installing Batteries in
Receiver
AA Batteries
Figure 14 - Installing Remote Receiver
OFF REMOTE
Receiver
Hook and
Loop Strip
on Bottom
of Receiver
Burner
Heater
Cabinet
2. Remove battery cover on receiver and
install batteries as shown in Figure 13.
Replace battery cover.
3. Remove adhesive backing on hook and
loop strip and attach to receiver in location
shown in Figure 14.
4. Place receiver with hook and loop strip’s
sticky side down in approximate location
on inside of heater shown in Figure 14.
5. Connect wires from receiver to wires on
control valve solenoid.
1
9
1
3
5
7
3
1
1
1
5
A
M
E
G
C
K
I
O
Figure 15 - Installing Batteries in Hand-
Held Remote Control
AAA
Batteries
Battery Cover
Remote Control
Figure 12 - Installing Base Feet (actual
heater may vary from illustration)
Sheet Metal Screw
Wood
Screw
Base Foot
Mounting Base Feet to Floor (Where
required by local code)
1. Remove front panel (see Removing Front
Panel of Heater, page 9).
2. Position heater with base feet in desired
location. Mark holes for drilling. Remove
heater with base.
3. For carpeted oors, make a small cut with
a sharp knife at marked locations prior to
drilling. If mounting base to a wood oor,
drill 1/8" diameter hole, 3/4" deep. (Do not
use anchors in wood oors).
If mounting base to a concrete oor, drill
with 1/4" diameter concrete drill bit, 1
3
/
8
" into
oor. Insert anchors completely into holes.
4. Reposition heater with base feet over
holes. Secure base to oor with wood
screws. See Figure 12.
INSTALLING REMOTE CONTROL
RECEIVER
Remote control receiver must be installed to
operate the remote control.
1. Locate two packages of AA batteries,
remote receiver and hook and loop strip in
hardware bag included with your heater.
INSTALLING BATTERIES INTO
REMOTE
1. Locate hand-held remote control in hard-
ware bag included with your heater.
2. Remove battery cover and insert supplied
batteries into remote control as shown in
Figure 15.
3. Replace battery cover.