Desa LDL3924PR Electric Heater User Manual


 
111515-01C
For more information, visit www.desatech.com
For more information, visit www.desatech.com
11
11
INSTALLATION
Continued
Figure 12 - Attaching Heater to Fireplace Floor
Masonry
Screw
Screw Holes
in Base
5. Center heater base and logs front-to-back and side-to-side
in fireplace.
6. Carefully remove logs without moving heater base.
7. Mark screw locations through one hole on each side of the
base (see Figure 12). If installing in a brick-bottom fireplace,
mark screw locations in mortar joint of bricks.
8. Drill holes at marked locations using 3/16" drill bit.
9. Attach base assembly to fireplace floor using two masonry
screws (in hardware package).
INSTALLATION
Installing Heater Base Assembly (Cont.)
Installing Batteries for Remote Receiver and Hand-Held Remote Control
INSTALLING BATTERIES FOR REMOTE
RECEIVER AND HAND HELD REMOTE
CONTROL
Four AA batteries and three AAA batteries are required to operate
this heater with the wireless hand-held remote control set. Four AA
batteries must be installed in the receiver and three AAA batteries
in the hand-held remote control unit.
Note:
Only use alkaline
batteries.
Installing Batteries in Receiver
1. Locate slot on battery cover of receiver (see Figure 13). Firmly
insert tool such as a small screwdriver, butter knife, or dime
into the slot and lift up to remove cover.
2. Insert 4 AA batterines into receiver. Positive and negative are
marked inside receiver casing.
Note:
Receiver will not func-
tion if batteries are not installed correctly.
3. Slide tab on cover into receiver housing and snap cover back
into place.
Figure 14 - Installing Batteries in Remote Control
Cover
Remote
Control
3 AAA
Batteries
Installing Battery into Remote
1. Remove remote cover (see Figure 14).
2. Insert 3 AAA batteries into remote control (see Figure 14).
Positive and negative are marked inside remote control cas-
ing.
Note:
Remote will not function if batteries are not in-
stalled correctly.
3. Slide remote cover back into place.
Figure 13 - Installing Batteries in Receiver
Cover
Receiver
Slot
4 AA
Batteries
Battery
Housing
Backup
Switch