Filter
Top Products
110399-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
17
17
1
2
3
4
5
Golden Oak Five-Piece Log Set
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place front log (#1) on top of the grate (see Figure 26). Log
will fit down between grate and front of chassis.
2. Rest middle log (#2) inside “U”-shaped cutouts in chassis (see
Figure 27).
3. Place rear log (#3) on back portion of chassis (see Figure 28).
Log will "hug" the burner (see Figure 29).
4. Place right top log (#4) over logs #1, 2 and 3 as shown in
Figure 29. Top log will sit down into indentions in these logs.
5. Place left top log (#5) over logs #2 and 3. Left top log will fit
into indentions in these logs.
IMPORTANT:
Make sure logs
do not cover any burner ports (see Figure 25, page 16).
6. Place lava rock around base of heater if desired.
Figure 26 - Installing Golden Oak 5-Piece Log Set - Log 1
INSTALLATION
Continued
Figure 27 - Installing Golden Oak 5-Piece Log Set - Log 2
Figure 28 - Installing Golden Oak 5-Piece Log Set - Log 3
Figure 29 - Installing Golden Oak 5-Piece Log Set - Logs 4 and 5
“U”-shaped Cutout
in Chassis
Grate
Chassis
Chassis
Burner
Middle Log (#2)
Front Log (#1)
Rear Log (#3)
INSTALLATION
Installing Logs (Cont.)