Filter
Top Products
- 20 - For more information, visit www.desatech.com
FINAL PREPARATION
1. Place the grate and log assembly back into position on the
grate stand as shown in your appliance Installation
Manual.
2. Close the glass door and tightly secure all four latches.
3. Replace the screen rod assembly and then the top and
bottom louver assemblies with the louvers pointing down.
The upper louver should have the brass strip on the bottom
and the bottom louver should have the brass strip on top.
The conversion is now Complete.
Refer to the section on Gas Supply Testing and Operating
Guidelines in your appliance Installation Manual
Mounting Screw s
Identification Label
Rubber Gasket
Figure 38 - Installing Pressure Regulator Assembly
WARNING: Test all gas piping and connections for leaks after installing or servicing. Correct leaks at once.
WARNING: Never use an open flame to check for a leak. Apply commercial leak test solution to all gas joints. Bubbles
forming show a leak. Correct all leaks at once.
WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's
instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these
instructions is not followed exactly, a fire, explosion, or production of carbon monoxide may result causing property damage,
personal injury, or loss of life. The qualified service agency is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation of the converted appliance is checked as specified in the
manufacturer's instructions supplied with the kit.