Filter
Top Products
www.desatech.com
108861-01F
22
FIREPLACE INSTALLATION
Continued
5. Place log #5 (top log) onto right pin of front log (#2) and the
smooth surface of crossover log (#4) as shown in Figure 48.
Make sure it is seated properly.
6. Place log #6 (left log) onto left pin of front log (#2) and the
smooth surface of rear log (#3) as shown in Figure 49. Make
sure it is seated properly.
7. For 42" series only, place log #7 onto right pin of top log (#5)
as shown in Figure 49. Make sure it is seated properly
8. Place lava rock along sides and front of rebox bottom in areas
that are visible only. It is not necessary to use all of the lava
rock provided.
problems.
9. Pull ember material apart into pieces no larger than a dime. Place
these pieces loosely and sparingly directly onto the exposed sec-
tion of the front burner and along the space between the burner
and grate prongs (see Figure 50). This will create the glowing
ember appearance as the ame touches the ember material. Do
not block air slots by using too much ember material in one area.
It is not necessary to use all of the ember material provided.
10. Close glass door, lock door latches, replace screen, and close
louvers (see Removing/Replacing Glass Door, steps 5 through
7, page 20).
WARNING: The glass door must be securely in place
Ember Material
Figure 50 - Placing Ember Material on Burner
Figure 48 - Installing Log No. 5
5
6
7
Figure 49 - Installing Log No. 6 (36" and 42" Series) and
Log No. 7 (42" Series Only)
42" Series Only