Filter
Top Products
www.desatech.com
108861-01F 21
FIREPLACE INSTALLATION
Continued
Figure 42 - Installing Rear Brick Panel
Figure 43 - Installing Left Side and Top Brick Panels
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs sup-
plied with replace.
Open louvers, remove screen, unlock door latches, and open glass
door. See Removing/Replacing Glass Door, steps 1 and 2, page 20. In-
stall logs according to instructions for replace model numbers.
1. Place log #1 (base log) onto pin on left front side of grate as
shown in Figure 44.
2. Rest left side of log #2 (front log) onto top of log #1. Place
right side of log onto second pin located on right side of grate
(see Figure 45).
3. Place log #3 (rear log) onto pins on rear of grate as shown in
Figure 46.
4. Place log #4 (crossover log) onto pins from both logs #2 and
#3 as shown in Figure 47.
5. Install rear brick panel rst. Rest bottom edge of panel on back
edge of grate (see Figure 42).
6. Install top brick panel (36" Series only) by resting on the top
of the rear panel. Hold the top brick panel in place and install
left side brick panel by sliding it between the grate and the side
of the rebox, securing top panel (see Figure 43).
7. Install the right brick panel using the same method described
8. Replace deector shield using screws removed in step 4.
9. Follow instructions on page 24 to install logs, lava rock, and
ember material.
10. Close glass door, lock latches on top and bottom of door and
replace screen (see steps 5 and 6 of Removing/Replacing Glass
Door, page 20).
11. Close top and bottom louvers.
Rear Brick Panel
Left Side
Brick Panel
Top Brick Panel
Figure 45 - Installing Log No. 2
Figure 44 - Installing Log No. 1
1
1
2
Figure 46 - Installing Log
No. 3
3
Figure 47 - Installing Log No. 4
4