Filter
Top Products
107068-01F
For more information, visit www.desatech.com
For more information, visit www.desatech.com
15
15
INSTALLATION
Installing Logs, Models CLD3018PA, CLD3018NA, CLD3018PT, CLD3018NT,
CLD3924PTA and CLD3924NTA (Cont.)
OPERATING HEATER Manually-Controlled Models
For Your Safety Read Before Lighting
INSTALLATION
Continued
Figure 22 - Installing Back Log (#2)
Figure 24 - Installing Crossover Log (#4)
Front Log (#3)
Notches
Grate Fingers
Figure 23 - Installing Front Log (#3)
Hole in
Grate Base
Back Log (#2)
Peg
Burner
Crossover
Log (#4)
Recess
Peg
OPERATING HEATER
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don’t try to repair it, call a qualified service techni-
cian or gas supplier. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
FOR YOUR SAFETY READ
BEFORE LIGHTING
MANUALLY-CONTROLLED MODELS
3. Locate the notches in the bottom of the front log (#3). Place the
front log on the grate fingers. Make sure the notches of the front
log line up with the grate fingers (see Figure 23).
4. Place crossover log (#4) onto the pin (right) on back log (#2) and
into the recess of the middle log (#1) (see Figure 24).
5. Add lava rock around base of heater if desired. Do not place
any lava rock on logs or burner.