Filter
Top Products
107068-01F
For more information, visit www.desatech.com
For more information, visit www.desatech.com
14
INSTALLATION
Installing Logs, Models CGS2718P, CGS2718N, CGS3124P and CGS3124N (Cont.)
Installing Logs, Models CLD3018PA, CLD3018NA, CLD3018PT, CLD3018NT,
CLD3924PTA and CLD3924NTA
INSTALLATION
Continued
Figure 19 - Installing Front Log
Front Log (#2)
Notch
Tabs of
Grate Base
Figure 20 - Installing Crossover Log
Crossover
Log (#3)
Notch
Rectangular Knob
Notch
Rectangular
Knob
2. Locate the notches on the back of the front log (#2). Slide
these notches over the tabs of the grate base (see Figure 19).
3. Locate the notches in the bottom of the crossover log (#3). Place
the crossover log on top of the back log and front log. Make
sure the notches of the crossover log line up with rectangular
knobs on top of the back and front logs (see Figure 20).
4. Add lava rock around base of heater if desired. Do not place
lava rock on logs or burner.
INSTALLING LOGS, MODELS CLD3018PA,
CLD3018NA, CLD3018PT, CLD3018NT,
CLD3924PTA AND CLD3924NTA
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to High, check to see
if flames contact any log. If so, reposition logs ac-
cording to the log installation instructions in this
manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place the base of the middle log (#1) in the U-shaped slots of
the grate base. The cutout on the right of the middle log should
fit over the burner (see Figure 21). Make sure the front of the
middle log is resting on the tabs of the grate base and the cut-
out area is centered over the burner “U” bend.
2. Locate pegs on the bottom of back log (#2). Slide these pegs
into the holes in the grate base behind the burner (see Figure 22,
page 15).
Figure 21 - Installing Middle Log (#1)
Middle Log (#1)
Tab
Burner
“U” Bend
U-Shaped Slot