Filter
Top Products
14
103425
UNVENTED (VENT-FREE) GAS LOG HEATER
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
INSTALLATION
Continued
3
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Slide rear log (#1) into place behind
rear burner. Make sure flat areas at bot-
tom of log are behind front burner (see
Figure 17).
2 . Slide bottom mid log (#2) into place in
behind front burner. Make sure tabs at
bottom of log are behind rear burner
(see Figure 18).
3. Place front log (#3) into place in front
of bottom mid log (#2) (see Figure 19).
Make sure notches on bottom rest on
grate prongs.
4. Finally place top log (#4) over bottom
mid log (#2) by matching the notches
under log (#4) with the raised blocks
of log (#2) (see Figure 20).
2
Tab
Figure 18 - Installing Bottom Mid Log
Bottom Mid Log (#2)
Rear Log (#1)
Front Log (#3)
Figure 19 - Installing Front Log
Figure 17 - Installing Rear Log
4
4
Figure 20 - Installing Top Log
Top Log (#4)