Filter
Top Products
11
103425
OWNER’S MANUAL
INSTALLATION
Installation Items Needed
• hardware package (provided with heater)
• approved flexible gas hose (not provided)
(if allowed by local codes)
• sealant (resistant to propane/LP gas, not
provided)
• electric drill with 3/16" masonry drill bit
1. Apply pipe joint sealant lightly to male
threads of gas connector and install into
regulator. Connect approved flexible
gas hose to gas regulator of heater (see
Figure 11).
IMPORTANT:
Hold gas regulator with
wrench when connecting fittings.
2. Position heater base assembly in fire-
place.
3. Mark screw locations through holes in
front of base. If installing in a brick-
bottom fireplace, mark screw locations
in mortar joint of bricks.
4. Remove heater base from fireplace.
5. Drill holes at marked locations using
3/16" drill bit. Drill at a 45° angle.
6. Attach base to fireplace floor using
masonry screws in hardware
package (see Figure 12).
7. Connect to gas supply. See Connecting
To Gas Supply, page 12.
Heater Gas
Regulator
Flexible Gas Hose (if
allowed by local codes)
Figure 11 - Attaching Flexible Gas Hose to Heater Gas Regulator
Figure 12 - Attaching Heater to Fireplace Floor
Masonry
Screw
Continued