Filter
Top Products
107123-01F
For more information, visit www.desatech.com
For more information, visit www.desatech.com
14
INSTALLATION
Installing Logs (Cont.)
INSTALLATION
Continued
Dual Burner Premium Aged Split Oak Models
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place the base of the middle log (#1) in the U-shaped slots of
the grate base. The cutout on the right of the middle log should
fit over the burner (see Figure 22). Make sure the front of the
middle log is resting on the tabs of the grate base and the cut-
out area is centered over the burner “U” bend.
2. Locate pins on the bottom of back log (#2). Slide these pins into
the holes in the grate base behind the burner (see Figure 23).
3. Place crossover log (#3) onto the pin (right) on middle log
(#1) and into the recess of the back log (#2). See Figure 24.
4. Locate the notches in the bottom of the front log (#4). Place
the front log on the grate fingers. Make sure the notches of the
front log line up with the grate fingers. See Figure 25.
5. With knot to right side, place smaller log piece (#5) over the
pin on the left side of the middle log. The smaller log will rest
on front log against the "knot" on the left. See Figure 26.
6. Place lava rock around base of heater if desired. Do not put
lava rock on logs on burner.
Burner
Tab
U-Shaped
Slot
Middle Log (#1)
“U” Bend
Pin
Hole in
Grate
Base
Back Log (#2)
Burner
Figure 22 - Installing Middle Log (#1)
Figure 23 - Installing Back
Log (#2)
Crossover
Log (#3)
Pin
Recess
Figure 24 - Installing Crossover
Log (#3)
Front Log (#4)
Grate Fingers
Notches
Figure 25 - Installing Front Log
(#4)
Figure 26 - Installing Log Piece
(#5)
Pin
Log Piece
(#5)
Dual Burner Biltmore Split Oak Models
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.