Filter
Top Products
3
104417
OWNER’S MANUAL
Figure 1 - VS24PR Shown
PRODUCT IDENTIFICATION
LOCAL CODES
Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
Batterymarch Park
New York, NY 10018
National Fire Protection Association, Inc.
1430 Broadway
Quincy, MA 02269
Note:
Where listed vented decorative logs
are required, thermostat operation is not
permitted.
24. This heater must not be connected to
any external electrical source.
25. Operating heater above elevations of
4,500 feet may cause pilot outage.
26. To prevent performance problems, the
use of a propane fuel tank of less than
100 lb. capacity is not recommended.
SAFETY
INFORMATION
Continued
UNPACKING
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
both realistic flames and glowing coals.
This heater is designed for vent-free opera-
tion with flue damper closed. It has been
tested and approved to ANS Z21.11.2 stan-
dard for unvented heaters. State and local
codes in some areas prohibit the use of vent-
free heaters. This heater may also be oper-
ated as a vented decorative (ANS Z21.60)
product by opening the flue damper (non-
thermostat operation only).
SAFETY PILOT
This heater has a pilot with an Oxygen
Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.
AUTO
MAN
OFF
STATUS
ONLO
HI
TEMP
Front Branch
Control Knob
Rear Log
Base Assembly
Front Burner
Piezo Ignitor
Rear Burner
Crossover Log
Middle Log
Selector
Switch
(Optional)
Flame
Adjustment
Knob
Remote
Control
(Optional)
OPTIONAL
REMOTE CONTROL
ACCESSORIES
There are four optional remote controls that
can be purchased separately for this log
heater:
• wall switch
• wall thermostat
• hand-held on/off remote
• hand-held thermostat remote.
See Accessories, page 25.
The wall thermostat or hand-held thermo-
stat may not be used where vented decora-
tive listing is required.
WARNING: Do not remove
the metal data plates attached to
the heater base assembly. The
data plates contain important
warranty information.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
1. Remove logs and heater base assem-
bly from carton.
Note:
Do not pick up
heater base assembly by burners. This
could damage heater. Always handle
base assembly by grate.
2. Remove all protective packaging ap-
plied to logs and heater for shipment.
3. Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.