Filter
Top Products
13
104417
OWNER’S MANUAL
4
4
Figure 18 - Installing Middle Log (#2)
Figure 19 - Installing Rear Log (#3)
INSTALLATION
Continued
Crossover
Log (#4)
Hole
Peg
Cutout
Figure 20 - Installing Crossover Log (#4)
INSTALLING LOGS
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Place front log (#1) on top of the grate.
Make sure the notches in the bottom of
the log fits over the grate prongs (see
Figure 17). Push back of log flush with
metal grate bar.
2. Rest middle log (#2) behind metal posts
on front burner. Make sure the grooves
in the bottom of the log fit over the
grate. Bring the log forward next to the
metal posts. The cutout on the middle
log must be on top (see Figure 18).
3. Slide the grooves in the back of the rear
log (#3) against the rear grate prongs.
Make sure the peg on the log is on top
(see Figure 19).
4. Place the crossover log (#4) on the back
log and the middle log. Make sure the
peg on the rear log is in the hole in the
bottom of the crossover log. The cross-
over log should fit in the cutout of the
middle log (see Figure 20).
Figure 17 - Installing Front Log (#1)
Grate
Prongs
Metal Grate Bar
Front Log (#1)
Notch
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Rear Log (#3)
Peg
Grate
Prong
Grate Prong
Rear
Burner
Groove in
Back of Log
Groove in
Back of
Log
Middle Log (#2)
Metal Post
Metal
Post
Groove
Groove
Grate